Amada S-2200CA, Operation Manual

Page: 99 / 210

CHAPTER 3: USING PROGRAMMING FUNCTIONS
IS-2200CA/4500CA INVERTER POWER SUPPLY
990-412 3-45
d. STEP 1–9
Set the welding current up (-down) ratio ( RATIO ) for each STEP .
e. COUNT 1–9
Set the number of welds ( COUNT ) for each STEP .
The sequence will proceed to the next STEP following completion of the specified number of
welds.
f. RP2
Set the number of repetition ( COUNT ) for STEP2 .
The sequence will proceed to the next STEP3 following completion of the specified number
of welds. STEP2 is repeated the set number of times, and the sequence will proceed to the
next STEP3 .
g. TD 1–9
Set the chip dress for each STEP . When TD is set, X is displayed.
For STEP with the tip dress setting, the tip dress error occurs following completion of the
specified number of welds.
h. CAP CHANGE
Set the cap change ( COUNT ) for STEP9 .
The cap change error occurs following completion of the specified number of welds for
STEP9 .
When the number of welds is set in CAP CHANGE , prior notice for cap change will be given
before the cap change error occurs.
Specify the number of welds to give prior notice how many numbers before the number of
welds (
STEP9 COUNT ) that the cap change error occurs.
For example, when STEP9 COUNT is 1000 (the number of welds that the cap change error
occurs) and CAP CHANGE is 10, prior notice is given when the stepper count is 990.
TD setting