Amada S-2200CA, Operation Manual

Page: 37 / 210

CHAPTER 1: SYSTEM DESCRIPTION
IS-2200CA/4500CA INVERTER POWER SUPPLY
990-412 1-17
The Power Supply writes data into FLASH ROM on the control board when a setting is changed or a
schedule data is copied. The
READY lamp on the front panel and the external READY signal are turned
off during writing. Check that the
READY
lamp is turned on to start welding.
It takes about 3 seconds maximum to change a setting, about 125 seconds to copy a schedule, and about
5 seconds maximum to initialize schedules in FLASH ROM. During that time, do not turn off the power.
MENU Key
Used to display the MENU screen. Press this key to return to MENU screen from any other screen.
CAUTION
No setting changes can be made while the start signal is ON or during a weld
sequence.
If a setting is changed during the welding sequence, an error message will
appear. Press the
TROUBLE RESET key to clear the message.
Also, when making a screen change to call up another setting schedule during
a welding sequence, the
TROUBLE RESET key will not work even if the
following screen appears. In this case, you need to recycle the power to the
Unit.