Amada S-2200CA, Operation Manual

Page: 44 / 210

CHAPTER 2: INSTALLATION AND SETUP
IS-2200CA/4500CA INVERTER POWER SUPPLY
2-6 990-412
8. Connect the ground cable to the chassis ground terminal to the right of the circuit breaker.
9. Slide the circuit breaker terminal cover back on to the circuit breaker.
10. Remove the four screws that secure the Line-Out Cover Plate on the bottom of the Power
Supply.
11. Drill appropriate hole(s) in the plate to receive the weld transformer power conduit(s).
NOTE: Remove all metal shards, then re-install the plate.
12. Install the weld transformer conduit to the plate and feed cables into the Power Supply.
13. Connect the ground cable to the ground lug.
14. Connect the two transformer cables to connectors labeled
U
and
V
in the power module.
( see next page )
INPUT POWER CONNECTIONS (3Ø)