Amada S-2200CA, Operation Manual

Page: 91 / 210

CHAPTER 3: USING PROGRAMMING FUNCTIONS
IS-2200CA/4500CA INVERTER POWER SUPPLY
990-412 3-37
NOTE: This screen shows initial settings. The display surrounded with frame changes
depending on the setting of WELD2 STOP/WELD COUNT and COUNTER on the MODE
SELECT screen.
a. PRESET TOTAL COUNT
The display changes depending on the setting of WELD2 STOP/WELD COUNT and
COUNTER on the MODE SELECT screen. The preset count is the count value set in advance.
When each count reaches the set value, E-28 (Count-up) is displayed and the
COUNT UP signal
is output.
When WELD2 STOP/WELD COUNT is WELD2 STOP and COUNTER is TOTAL, the
PRESET TOTAL COUNT is displayed.
When WELD2 STOP/WELD COUNT is WELD2 STOP and COUNTER is GOOD, the
PRESET GOOD COUNT is displayed
.