Amada S-2200CA, Operation Manual

Page: 106 / 210

CHAPTER 3: USING PROGRAMMING FUNCTIONS
IS-2200CA/4500CA INVERTER POWER SUPPLY
3-52 990-412
(ANALOG OUT), and CO1/WE2 and CONTINUE blink. The measured value input in the force
input (ANALOG IN) is displayed at the monitor of CO1/WE2.
CO2/WE3
The sequence proceeds from CO1/WE2 to CO2/WE3 by pressing the ENTER key or input the
STEP MODE signal. The force set in CO2/WE3 is output to the electro pneumatic proportional
valve (ANALOG OUT), and CO2/WE3 and CONTINUE blink. The measured value input in
the force input (ANALOG IN) is displayed at the monitor of CO2/WE3.
HOLD
The sequence proceeds from CO2/WE3 to HOLD by pressing the ENTER key or input the STEP
MODE signal. The force set in HOLD is output to the electro pneumatic proportional valve
(ANALOG OUT), and HOLD and CONTINUE blink. The measured value input in the force
input (ANALOG IN) is displayed at the monitor of HOLD.
Turning off the step operation mode
The step operation mode ends by pressing the
ENTER
key or input the
STEP MODE
signal.
Open the 1ST signal. The force output to the electro pneumatic proportional valve (ANALOG
OUT) becomes the setting on the setting on the PRESSURE REGULATOR screen, and
HOLD
and
CONTINUE
stops blinking.
d. SQD
Set the force of the electro pneumatic proportional valve (ANALOG OUT) output during
SQD.
e. SQZ
Set the force of the electro pneumatic proportional valve (ANALOG OUT) output during
SQZ.
f. WE1
Set the force of the electro pneumatic proportional valve (ANALOG OUT) output during
WE1.
g. CO1/WE2
Set the force of the electro pneumatic proportional valve (ANALOG OUT) output during
CO1/WE2.
h. CO2/WE3
Set the force of the electro pneumatic proportional valve (ANALOG OUT) output during
CO2/WE3.