Amada S-2200CA, Operation Manual

Page: 57 / 210

CHAPTER 3: USING PROGRAMMING FUNCTIONS
IS-2200CA/4500CA INVERTER POWER SUPPLY
990-412 3-3
3. SCHEDULE Screen
Up to 255 welding schedules can be set on the Power Supply. These schedules are indicated as
SCHEDULE #1 to #255.In the SCHEDULE screen, there is a Current and time setting screen and a
PULSATION and transformer screen.
CURRENT and TIME Setting Screen
This screen is used to set the SCHEDULE No., length of weld time, welding current, and so on.
The ms mode or CYC mode can be changed via WELD TIME (Refer to
Chapter 3, Section 10 ) on
the MODE SELECT screen.
NOTE: The unit, resolution, and setting range change depending on the settings of CTRL/CURR
RANGE.
a. SCHEDULE #
Select from #1 to #255 to set the SCHEDULE. Normally select #1 first, then select additional
schedules in sequential order.
b. TIME
Set the time for each operation during welding. Units of time are in ms or CYC. The screen
above is in ms setting. CYC can be selected via the MODE SELECT screen. See the Timing
Chart for each operation.
(b)
(c)
(a)
(d)
(e)
(f)
(g)