Amada S-2200CA, Operation Manual

Page: 85 / 210

CHAPTER 3: USING PROGRAMMING FUNCTIONS
IS-2200CA/4500CA INVERTER POWER SUPPLY
990-412 3-31
j. NEXT
When the cursor () is displayed, pressing the ENTER key will change the display to the MODE
SELECT (2) screen.
k. STEPPER MODE
Select whether or not to perform step-up (step-down) operation, refer to the STEPPER COUNT
Screen.
OFF Step-up (step-down) will not be performed.
FIXED
Step-up (step-down) will be performed. (Stepwise)
LINER
Step-up (step-down) will be performed. (Linear)
NOTE:
RATIO
has an effect on
HEAT
only. Fixed for
UF/DL
. When the
HEAT
value multiplied
by RATIO falls below the UF/DL value, an error occurs.
The COUNT value works as each STEP value. Example: STEP1 0020 STEP2 0010 indicates
that
STEP1
is 20 times and
STEP2
is 10 times. The conditions for stepper count-up is the same
as the TOTAL counter.
l. SCHEDULE
Sets the selection method of schedule number.
EXT Selects the schedule number by binary of the I/O terminal strip.
INT
Selects the schedule number by the SCHEDULE number of MA-660A .
(see Note)
NOTE: When setting SCHEDULE to INT, be sure to connect MA-660A and select the
SCHEDULE screen or the MONITOR screen.
(k)
(l)
(m)
(n)
(r)
(t)
(u)
(o)
(p)
(q)
(s)
(v)