Whirlpool ADVANTECH CAE2761K, Инструкция по установке, эксплуатации и обслуживанию

Страница: 24 / 178

2-10
6. The supply line shall be equipped with a
shutoff valve installed within 6 feet (1.8 m)
of dryer in accordance with the American
National Standard National Fuel Gas Code,
ANSI Z223.1—latest edition*. In Canada,
an individual manual shutoff valve must be
installed in accordance with the B149 in-
stallation codes CAN/CGA B149.1 and
CAN/CGA B149.2**. This valve should be
located in the same room as the dryer and
should be in a location that allows ease of
opening and closing. Do not block access
to the shutoff valve.
10. Make sure that the lower edges of the
cabinet, plus the back and bottom sides of
the dryer are free of obstructions to permit
adequate clearance of air openings for com-
bustion air (see page 2-8 for minimum
spacing requirements).
11. For ease of installation, operation and ser-
vicing (if ever needed) adequate space
should be provided around the dryer.
12. A 1/8
″
NPT plugged tapping, accessible for
gauge testing, must be installed immedi-
ately upstream of the gas supply connec-
tion to the dryer. The dryer must be discon-
nected from the gas supply piping system
during any pressure testing of the system at
test pressures in excess of 1/2 psig. The
dryer must be isolated from the gas supply
piping system by closing the equipment
shutoff valve during any pressure testing of
the gas supply piping system at test pres-
sures equal to or less than 1/2 psi (3.45 kPa).
Copies of the standards listed above may be
obtained from:
* American Gas Association
1515 Wilson Blvd.
Arlington, Virginia 22209
** CSA International
8501 East Pleasant Valley Road
Cleveland, Ohio 44131-5575
rigid pipe
shutoff valve
“open” position
to dryer
gas supply line
7. If the dryer is installed in a confined area
such as a bathroom or closet, provision
must be made for enough air for combus-
tion and ventilation. Check governing codes
and ordinances.
8. If local codes and ordinances permit, it is
recommended that new flexible metal tub-
ing, design-certified by the AGA or CSA, be
used for connecting the dryer to the gas
supply line. (The gas feed pipe which ex-
tends through the lower rear of the dryer is
provided with 3/8
″
metal pipe thread.)
9. If rigid pipe is used as a gas supply line, a
combination of pipefittings must be used to
obtain an in-line connection to the dryer.