Whirlpool ADVANTECH CAE2761K, Инструкция по установке, эксплуатации и обслуживанию

Страница: 142 / 178

6-14
SERVICE ROUTINE
1. Perform all steps under “Access Mode” on
page 6-13.
2. Push and release keypad position 2
(MEDIUM). MEDIUM LED starts blinking to
confirm keypad push.
3. Refer to new keypad functions in the table
below.
KEYPAD POSITIONS
READ LIFETIME CYCLE COUNT
1. Perform all steps under “Access Mode” on
page 6-13.
2. Lifetime Cycle Count is displayed for about
one minute then it goes back showing the
vend-price. Keypad #6 (START) can be
pushed to exit this routine before the one
minute expires.
LED TEST ROUTINE
1. Perform all steps under “Access Mode” on
page 6-13.
2. Push and release keypad position 5 (OFF).
All LEDs light and the digits show “88888”.
3. Push and release keypad #6 (START) to
return to show cycle count.
4. Push keypad #6 a second time to exit the
test routine.
HIGH
1
MEDIUM
2
LOW
3
ON
4
OFF
5 6
START
DISPLAY EXPLANATION
Service person placed machine out of service. See
MANUAL OUT OF SERVICE.
Machine has been set to be unavailable for customer
use by means of one of the three owner “special”
prices. See SP 1, SP 2 and SP 3 (special price).
No money device is enabled during machine setup.
Please enable the coindrop, coinslide and/or Smart
Card. See
OWNER SETTINGS
.
A coindrop error has occurred. Possible reasons:
Owner Setting is enabled but coindrop is not
installed.
Coindrop connector is unplugged.
Coindrop connector is plugged into the wrong
connector.
A coin is stuck inside the coindrop mechanism
Coindrop device is defective.
See
OWNER SETTINGS.
An error has occurred with an auxiliary device, such
as a Smart Card unit not plugged into connector of
control board. (The Owner Setting is enabled but
Smart Card is not installed.) See
OWNER SETTINGS.
SERVICE ROUTINE KEYPAD
FUNCTIONS
POSITION MODE FUNCTION
1 HIGH High bias heater setting
2 MEDIUM Medium bias heater setting
3 LOW Low bias heater setting
4 ON
Motor
ON/OFF -
heater turns off when
motor is
OFF
5
OFF
Heat
ON/OFF
- heater turns off when
motor is
OFF
6 START Exit Service Routine
MANUAL OUT OF SERVICE (OFF)
This procedure allows the service person to
take the machine out of service for needed
repairs. The display shows “OFF” when set.
The display shows the vend-price when put
back into service.
1. Perform all steps under “Access Mode” on
page 6-13.
2. Push and release keypad position 5 (OFF).
All LEDs light and the digits show “88888”.
3. Push and release keypad position 4 (ON).
“Out” appears on the display a short time to
show the new status.
4. Push and release keypad #6 (START) twice
to exit. The word “OFF” now replaces the
vend-price.
5. To place the machine back into service,
perform steps 1 through 3 a second time.
The word “In” appears on the LED display
for a short time to show that the new status
took effect.
6. Press keypad #6 twice to exit the service
mode. The vend-price replaces the word
“OFF,” and the machine is now available for
customer use.
Off Codes
The display shows the word “OFF” to inform
the customer the machine is out of service. If
money is added to the machine, it will be lost.
Refer to the “Off Codes” table.