Whirlpool ADVANTECH CAE2761K, Инструкция по установке, эксплуатации и обслуживанию

Страница: 172 / 178

5. If the bulkhead clip (Figure 1) is in place as illustrated
proceed to step 8. If clip is not in place, the dryer top
must be removed.
6. Remove the 2 T-15 Torx screws from the console and
rotate the console back on its two (2) hinges into the
service position (Figure 3).
7. Remove the three-rear panel to cabinet screws and
gently slide the cabinet top forward to reveal the har-
ness-mounting hole in the bulkhead.
NOTE: If the factory installed front lock blank has been
replaced with an optional top front lock, the lock must be
removed in order to remove the dryer top.
8. Pull any excess harness slack from the drum area up
into the console, and secure the harness clip(s) into
the rear panel and or bulkhead hole(s) (Figures 1, 2,
4). If the harness is too tight and cannot be clipped in
using the existing clip(s), new clip(s), (part # 3391018)
can be added.
FIGURE 4. LOCATION OF SECOND CLIP
(USED ON METERCASE MODELS ONLY WHEN FACTORY
CLIP CANNOT BE PULLED INTO POSITION)
9. The additional clips, (part # 3391018) should only be
added if the harness is too tight to secure into the
mounting hole(s) with the existing clip(s). Attach the
additional clip(s) onto the harness when required
immediately above the existing clip(s) within 1". To
attach the clip(s), the bulleted end remains on top of
the harness, the free end is looped under the harness
and pulled tight with pliers (Figure 3). Cut off any free
length.
10. On full console models, attach the harness clip im-
mediately above the shrink wrapped section of the
harness (figure 5). Secure the clip onto the harness
as detailed in step 9.
FIGURE 5. HARNESS CLIP SECURED IN REAR PANEL
IN ORIGINAL POSITION, METERCASE MODELS
11. Cut off excess free length of clip’s zip strip.
12. Place rubber insulator part# 304825 over the exposed
screw.
13. Snap the new clip(s) into the existing hole(s) on the
back panel or bulkhead. Make sure the harness does
not contact the the drum (Figure 6).
FIGURE 6. PLACEMENT OF NEW CLIP
ON HARNESS, FULL CONSOLE MODELS
FIGURE 3. T-15 TORX
S H R I N K - W R A P P E D
SECTION OF WIRE
H A R N E S S
NEW CLIP
LOCATION
14. Check to see that the accessory plug connected to
the black and white wires pulled free from the rest of
the harness (Figure 7).
SCREW INSULATOR
PART # 304825
INSTALLED OVER
EXPOSED SCREW
CLIP LOCATION
IN BACK PANEL
A C C E S S O R Y
PLUG FREED
FROM HARNESS
FIGURE 7. FULL CONSOLE MODELS
15. Reassemble unit and reconnect electrical service, in-
sert coins, tokens or user card and test operation.