Whirlpool ADVANTECH CAE2761K, Инструкция по установке, эксплуатации и обслуживанию

Страница: 21 / 178

2-7
17. If washer is not level, adjust the front legs up
or down. Make final check with level. Best
results are obtained when the washer is
tilted 1/4 bubble toward the rear and level side-
to-side. When washer is level, use wrench to turn
nuts on front legs up tightly against washer
base. If nuts are not tight against washer base,
the washer may vibrate.
18. Check that all parts are now installed. If
there is an extra part, go back through steps
to see which step was skipped.
19. Turn on water faucets and check for leaks.
Tighten couplings if there is leaking. Do not
over tighten; this could cause damage to
faucets.
20. Check that you have all of your tools. Check
that the shipping strap with 2 cotter pins and
plug was removed from the back of the
washer and used to secure the drain hose.
If entire strap is not removed, washer may
vibrate and be noisy.
21. Untape power supply cord.
22. Plug into a grounded 3-prong outlet.
23. Install the chosen money acceptor per the
instructions under the appropriate money
acceptor section of this Job Aid.
16. Check washer level by placing a level on
top of the washer, first side-to-side, then
front-to-back.
MOVING THE WASHER
To move the washer to a new location, perform
the following steps:
1. Remove the front legs from the base of the
washer.
2. Place both rear leveling legs in the upper
position and tape them securely in place.
3. Apply tape to the side and bottom of the
cabinet near the rear.
4. Open the washer lid, wedge a blanket be-
tween the tub ring and the cabinet top to
keep the tub from moving.
5. Move the washer to the desired location. Be
careful not to drop the washer while using a
hand truck.
Wedge blanket
between tub ring
and cabinet top
Remove front legs
Tape rear
legs in “up”
position
Tape 2
sides
NOTE: Do not
place blanket
in this area to
protect hidden
lid switch
Hidden
Lid Switch