Whirlpool ADVANTECH CAE2761K, Инструкция по установке, эксплуатации и обслуживанию

Страница: 70 / 178

4-12
6. To remove the motor:
a) Remove the pump (see step 4 for the
procedure).
b) Raise the locking arm and disconnect
the wire connector from the motor.
c) Disconnect the two wires from the mo-
tor start capacitor terminals.
d) Remove the hex-head screw from each
of the two motor mounting spring clips.
5. To remove the motor start capacitor:
a) Disconnect the two wires from the mo-
tor start capacitor terminals.
b) Loosen the hex-head screw on the
capacitor clamp and slide the capaci-
tor out.
Spring Clip Screw
Motor Start
Capacitor Wires
e) Support the bottom of the motor with
one hand to keep it from dropping, then
pry the end of the top spring clip off the
motor with a screwdriver, (see the round
inset), and remove the lower spring
clip.
f) Lower the front of the motor until the
motor coupler pins disengage from the
motor coupler isolator, and remove the
motor.
Pry Off Spring Clip
Isolator
Motor Coupler
g) Remove the following components
from the motor:
• Motor Coupler
• Motor Start Capacitor & Clamp
• Rubber Motor Mounts (4)
• Cardboard Shield
Motor Coupler
Rubber Motor Mount
Cardboard
Shield
Motor Start Capacitor & Clamp
Isolator
Spring Clip Screw
Clamp Screw
Motor Wire Connector Raise
Locking Arm To Release