Whirlpool ADVANTECH CAE2761K, Инструкция по установке, эксплуатации и обслуживанию

Страница: 171 / 178

WHIRLPOOL COMMERCIAL ONL WHIRLPOOL COMMERCIAL ONL
WHIRLPOOL COMMERCIAL ONL WHIRLPOOL COMMERCIAL ONL WHIRLPOOL COMMERCIAL ONLYYYYY
LAUNDRY PRODUCTS REFRIGERATION PRODUCTS KITCHEN PRODUCTS
COMMERCIAL POINTERS: www.whirlpoolcorp.com/cltpsc, TECHNICAL INFORMATION, SERVICE POINTERS
EMS1000 and AD EMS1000 and AD
EMS1000 and AD EMS1000 and AD EMS1000 and ADV
V
V V VANTECH™ GAS
ANTECH™ GAS
ANTECH™ GAS ANTECH™ GAS ANTECH™ GAS
AND ELECTRIC DRYERS AND ELECTRIC DRYERS
AND ELECTRIC DRYERS AND ELECTRIC DRYERS
AND ELECTRIC DRYERS
L8178269 L8178269 L8178269 L8178269 L8178269
October 2002 October 2002 October 2002 October 2002 October 2002
3 3
3 3 3
The wiring harness is not properly secured in the console.
ELECTRIC DRYER GAS DRYER
MODELS MODELS
METERCASE MODELS YCEE, CEE2760KQ0 CGE2761KQ0
YCEP, CEP2760KQ0 CGP2761KQ0
FULL CONSOLE MODELS CEE2790KQ0 CGE2791KQ0
COMPLAINT:
CAUSE:
The factory wiring harness clips were mispositioned on
the wiring harness and did not align with the mounting
holes on the dryer rear panel and bulkhead. As a result the
wiring harness may not be properly secured at one or both
mounting points.
SOLUTION:
Install service harness clip part number 3391018 and in-
sulator 304825 as detailed below:
NOTE: On electric dryers the control panel should only be
open with the power cord cover in place. If the power cord
cover is removed with the console in the service position
and power is applied, there is a risk of shock and product
damage.
1. If the unit is still in the carton, confirm that there is not
a blue dot on the carton model/serial tag label, indi-
cating that the unit has already been serviced. If a
blue dot is present, the repair has been implemented
and no action need be taken.
2. If the unit is uncartoned proceed to step 4.
3. If there is no blue dot present open top flaps of carton
with dryer upright. All repairs can be made without
removing dryer from carton.
4. Verify that both the rear bulkhead clip, located on the
upper right rear facing the back of the unit (Figure 1)
and the console rear panel clip (Figure 2) are in place.
On some units the console rear panel warning label
may be placed over the harness clip hole location.
Inspect the sticker to locate the hole and insure the
clip is installed. It may be necessary to open a hole in
the label to install or insure installation of the clip. Do
not remove the warning label. If both clips are in place
in the back panel and bulkhead, no repair is necessary.
FIGURE 1
HARNESS CLIP
INSTALLED IN
CONSOLE REAR
PA N E L
WARNING LABEL,
WHICH MAY HAVE
BEEN PLACED
OVER CLIP HOLE.
FIGURE 2
HARNESS CLIP
INSTALLED IN
BULKHEAD