Whirlpool ADVANTECH CAE2761K, Инструкция по установке, эксплуатации и обслуживанию

Страница: 19 / 178

2-5
5. Move washer close to final position. Put
the “hooked” end of drain hose into the
standpipe. Estimate length of drain hose
needed when washer is in final position.
Hose must be cut exactly to length so the
“hooked” end is held tightly over edge of
standpipe. If drain hose is too long, cut
straight end of hose.
(Do not cut the
“hooked” end of drain hose.) Do not
force excess length of drain hose down the
standpipe. This could cause siphoning. See
step 8.
4. Attach hose to bottom inlet valve opening
first. Then second hose to top inlet. Tighten
couplings by hand; then use pliers to make
an additional two-thirds turn. Slide washer
onto cardboard or hardboard before mov-
ing across floor.
Inlets are plastic.
Do not strip or
crossthread.
3. Insert a flat washer into each end of the in-
let hoses. Check that washers are firmly
seated in couplings.
8. Put the “hooked” end of drain hose into the
standpipe. Tightly wrap the shipping strap
around the standpipe. Push plug into the
nearest hole in the shipping strap. Check
that hose is not twisted or kinked and is
securely in place.
6. Place hose clamp over washer drain con-
nector. Push drain hose onto washer con-
nector. Use pliers to open clamp and slide
clamp over drain hose. Check for good fit.
7. Measure and mark a point approximately
16
″
(40.6 cm) from the plug end of
the shipping strap. Cut the shipping strap
at this point.
40.6 cm