Toshiba Estia RUA-CP1701H, Руководство по обслуживанию

Страница: 101 / 164

Monobloc Outdoor Unit Service Manual
100
10.1.2.2. User Configuration Table
Access type: Read/Write
TABLE NAME: UI_CONF, PIC Table Type: 10H, instance 2
PAR. NAME RANGE DEFAULT UNIT DESCRIPTION
521 ui_type 0 to 3 0 - User Interface Type
1
522 ui_accss 0 to 3 3 - Parameter Access from UI
2
523 ui_tmt 0 to 240 60 s Interface Comm. Timeout
3
524 ui_back 0 to 7 2 - Backlight Timeout
4
525 ui_buzz No / Yes No - Buzzer on key press
526 timebrod No / Yes Yes - Interface Time Broadcast
5
527 ser_pass 0 to 9999 120 - Service Password
528 usr_pass 0 to 9999 0 - User Password
1.User interface type
0 = No user interface (WUI will not initiate communication)
1 = Remote control by contacts
2 = WUI remotely installed in the house (Remote)
3 = WUI locally installed on the unit (Local)
Note: If parameter 521 is set to "0", a WUI “Pocket” (used by a technician) can be temporarily connected to the unit for
parameters configuration.
Then, if this parameter 521 is set to "1", the WUI that is connected to the unit can be used for unit servicing and
monitoring, but the Operating Mode and Occupancy Mode selection will not be operative.
UI
Type Unit
setting Unit
Control Unit
Monitoring Scheduling Temp.
Type
Display Remarks
0
   
No Only
Time
and
DOW WUI installed but not used.
WUI only responds to CCN
commands.
WUI used for unit configuration.
1
   
Water
Temp Normal Unit controlled by remote contacts
or unit is a Follower unit.
WUI used for unit configuration
and monitoring.
2
   
Air Temp Normal WUI installed in the house.
3
   
Water
Temp Normal WUI installed on the unit.
2. Parameter access for UI
0 = Access to parameters not allowed
1 = Access to User parameters only
2 = Access to User and Service parameters
3 = Access to User, Service and Factory parameters
3. UI communication timeout
If no communication message is received from the User
Interface for more than the timeout delay, the unit will be
stopped and the alarm will be activated. If this parameter
is set to 0, the communication timeout is ignored.
4. Backlight timeout
The backlight is switched off when no key is pressed
within a configured period of time:
0 = Backlight always off (disabled)
1 = 15 seconds 2 = 30 seconds
3 = 1 minute
4 = 2 minutes
5 = 5 minutes
6 = 30 minutes
7 = Always on (Backlight is always ON)
5. Time broadcaster
No = UI shall read the Date and Time in the Main
Controller
Yes = UI shall broadcast Date and Time over the Network
bus
IMPORTANT: In order to make any changes introduced
in this menu effective, the power cycle is required.