12778474-002-2 Revision F – March 2004
TSG-3800 User’s Guide 309
System Administrator’s Reference
Establishing Communications
Figure B-1.
Connecting a Computer to the Comm A Port
To establish communications (and log in) through either serial port, perform the
following steps.
1. Ensure that the required equipment listed in
Table B-1
is available.
2. Connect one end of the straight-through RS-232 cable to the serial connector on
the computer.
3. Connect the other end of the cable to either Comm A on the CPU module or
Comm B on the rear panel of the TSG-3800.
4. Power up the computer and establish a connection from the computer to the
TSG-3800 using terminal emulation software, such as HyperTerminal or
ProComm Plus. Ensure the terminal emulation software is configured for VT-100
emulation, 8 data bits, no parity, 1 stop bit, and 9600 baud rate.
5. Press
Enter
.
If the
tsg->
command prompt and the name of the TSG appears
on your screen, then communications are established. Otherwise, the command
prompt
User Name:
appears.
6. Type your user name and press
Enter
. The command prompt
Password:
appears.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com