Raven Envizio Pro, Инструкция по установке и эксплуатации

Страница: 178 / 287

CHAPTER
9
P/N 016-0171-493 Rev. I 163
Chapter 9
Using AccuBoom™
Introduction
AccuBoom is an automatic boom or implement section control feature that can be used in conjunction with the
Envizio Pro field computers. The AccuBoom feature allows the field computer to automatically control boom or
implement sections by referencing the as-applied or coverage map for each control channel. When AccuBoom
detects a section entering an area where a product has previously been applied, AccuBoom will automatically
turn that section off. When the section leaves the previously applied area, AccuBoom automatically turns the
section back on.
Note:
Prior to using the AccuBoom feature with the Envizio Pro, the supporting hardware components
must be purchased and installed for the specific machine. Contact a local Raven dealer for more
information.
CAN Switch Box
If a Raven CAN Switch Box, or the Raven Switch Pro™ switch box, is installed with the field computer, the
section switches must be in the ‘Accu’ position to allow AccuBoom control for the assigned sections. If the
section switches are in the ‘On’ or ‘Off’ position, the AccuBoom system will treat the section as manually
overridden and will not automatically turn the section on or off based on previous application areas or field
boundaries.
Note:
The CAN Switch Box must be used as the primary control interface for section, master or product
control status. Refer to the Switch Pro Installation and Reference Guide for additional assistance
with using the Switch Pro with the control system.
Make sure to toggle the master switch to the off position when closing or exiting a job to avoid
unintentional product application once the field computer or control console closes application
management functions
. It is also good practice to shut off product and section switches when the
application system is not being used.