Raven Envizio Pro, Инструкция по установке и эксплуатации

Страница: 166 / 287

P/N 016-0171-493 Rev. I 151
Tools Menu
7
Manually Configure Sections
If the boom or implement is not aligned end-to-end on the swath midpoint, the boom or implement sections will
need to be manually configured.
1.
Select Manually Configure to begin locating boom or implement sections. The Section Location screen will
be displayed. The currently entered offsets for the first section (if any) are displayed in the Left/Right and
Fore/Aft buttons.
Note:
The reference point for measuring the section left/right and fore/aft offsets depends upon the
implement type selected prior to configuring the section configuration.
•
Self-propelled or mounted Implement - The reference point is the antenna position. Offsets
must be measured from the antenna to the midpoint of each section.
•
Trailed Implement - The reference point is the implement pivot point, usually the center of the
implement wheel base. Offsets must be measured from the implement pivot point to the
midpoint of each section.
•
Trailed Implement with Tow Between - The reference point is the rear hitch of the tow
between implement. Offsets must be measured from the rear hitch to the midpoint of each
section.
Review the Offsets and Implement Type Selection section on page 142 for details on measuring
section offsets.
2.
Touch the left/right button to enter a left or right offset for the first section. Enter a negative value if the
center of the section is located to the left of the of the DGPS antenna.
3.
Touch the fore/aft button to enter a fore or aft offset for the first section. Enter a negative value if the center
of the section is located behind the DGPS antenna.
4.
Touch the Next icon and repeat steps 2 and 3 to continue programming individual section locations.
When finished, touch the Next icon to return to the Configure Sections screen.
5.
Touch the Accept icon to return to the Section Configuration screen.