Raven Envizio Pro, Инструкция по установке и эксплуатации

Страница: 182 / 287

9
P/N 016-0171-493 Rev. I 167
Using AccuBoom™
Look Ahead
Set the AccuBoom Look Ahead setting to the number of seconds (determined by speed) the field computer is
allowed to scan in front of the current vehicle position for zone map features. The On and Off Look Ahead
settings may help to compensate for the time required to open or close control valves based upon the zone
map.
A non-zero “On” Look Ahead value allows AccuBoom to begin opening control valves while a non-zero “Off”
Look Ahead will allow AccuBoom to begin closing valves.
Note:
Setting the Look Ahead values too high may cause the control valves to begin opening or closing
too early. This may cause overlaps, skips, or undesirable product application in some areas.
Generally, these settings should not exceed 5 seconds and a value between 1 to 2 seconds will
yield the best results.
Use Look Ahead Distance
Enable the Use Look Ahead Distance option on the AccuBoom Configuration screen to set look-ahead values
in units of distance rather than time.
Note:
The vehicle must travel at a constant speed while using the look ahead distance.
Enable Zero Speed Override Popup
Check the Enable Zero Speed Override Popup option to display the AccuBoom Popup screen during
AccuBoom enabled jobs.
Enabling AccuBoom™
To use the AccuBoom feature with the product control system, AccuBoom must be enabled. AccuBoom cannot
be enabled while a job is in progress. To Start or Resume a job with the AccuBoom feature enabled:
1.
Select the Start Job icon on the Home screen.