Raven Envizio Pro, Инструкция по установке и эксплуатации

Страница: 54 / 287

5
P/N 016-0171-493 Rev. I 39
Startup, Initial Setup, and Setup Wizards
Touch Screen Calibration
The touch screen displays an arrow in the location last selected. If the arrow does not appear in the location
previously touched, the touch screen may need to be recalibrated.
Note:
The Envizio Pro does not require re-calibration of the touch screen every time the console is
powered on. Use this procedure only if you are having difficulty with the user interface or the
cursor appears in a different location than selected on the touch screen.
To Re-calibrate the Touch Screen
1.
When prompted, touch the screen to begin re-calibration of the touch screen. The first calibration target will
appear.
Note:
The operator has approximately seven seconds to touch the screen to begin the calibration
process.
2.
Touch the center of the target.
Note:
Each of the four following targets will require the operator to touch the center of the target.
3.
After all of the calibration targets have been completed, test the touch screen calibration by touching in
various areas of the screen.
4.
Two options will appear in the lower left corner of the screen:
•
Touch ‘Accept’ to apply the screen re-calibration and start the field computer.
•
Touch ‘Cancel’ to reject the screen calibration. The field computer will re-apply the previous
touch screen calibration before starting the Envizio Pro management software.