Raven Envizio Pro, Инструкция по установке и эксплуатации

Страница: 263 / 287

Appendix J
248 Envizio Pro™ and Envizio Pro II® Installation and Operation Manual
AccuBoom™ Configuration
Note:
AccuBoom, automatic section control, features are only available for the Bogballe Calibrator Zurf
serial interface.
The turn-on/turn-off look-ahead values may be adjusted after this procedure is completed to
customize AccuBoom performance to the specific vehicle and spreader.
Use the following procedure to calibrate the AccuBoom turn-on and turn-off look-ahead values to the spreader:
1.
From the field computer Home screen, touch the Tools Menu icon and touch the Product Control icon within
the System submenu.
2.
On the Product Control Configuration screen, select the AccuBoom button to display the AccuBoom
Configuration screen.
3.
Enable the “Use Look Ahead Distance” option at the bottom of the screen by touching the box until a check
is displayed.
4.
Touch the Off Look Ahead button and use the up or down arrows to set the off look-ahead value to the
spread distance value determined from the appropriate spread chart.
5.
Touch the green check mark to return to the AccuBoom Configuration screen.
6.
Touch the On Look Ahead button and use the up or down arrows to set the on look-ahead value to zero.
Note:
The procedure above will configure the AccuBoom system for general operation with the spreader.
To fine tune AccuBoom performance for the specific system and the specific vehicle, adjust the
look-ahead values in small increments until the desired performance is achieved.
See Chapter 9, Using AccuBoom™, for more information on setting up and operating the
AccuBoom feature on the field computer.
Option
Enabled