Raven Envizio Pro, Инструкция по установке и эксплуатации

Страница: 134 / 287

P/N 016-0171-493 Rev. I 119
Tools Menu
7
Max Pressure Alarm
Note:
The low supply alarm value will only be available if the control channel is configured for AccuFlow
HP+ system control. Refer to Application Type section on page 100 for additional assistance with
the application type settings.
Enter the maximum pump pressure in PSI allowed for the AccuFlow HP™ Plus system. If the pressure
monitored on the pump outlet rises above the configured value, the field computer will trigger an alert for the
operator. The field computer will provide an operator alert if the system pressure reaches the configured value
during anhydrous ammonia applications. The pressure alarm may be set between 0 to 250 PSI [0 to 1724
kPa]. Enter a value of zero to disable the maximum pressure alarm condition.
Off Rate Percent
Enter the percentage at which the Off Rate alarm will activate. The Off Rate alarm activates when the actual
rate differs from the target rate by the programmed value for longer than five seconds.
The off rate alarm percent value will also determine the coverage mapping colors during an active job.
Current Alarms
Touch the Current Alarms button to display any current product alarms.
Section Assignments
The Section Assignment screen allows the operator to assign products to a section. Place a green check mark
below a section to assign the selected product to that section.
Note:
The vehicle or implement’s plumbing must accommodate the selected section assignments.