Raven Envizio Pro, Инструкция по установке и эксплуатации

Страница: 161 / 287

Chapter 7
146 Envizio Pro™ and Envizio Pro II® Installation and Operation Manual
Product in Front Option. Select the option at the bottom of the screen if the product sections are in front of
the implement pivot point.
3.
To enter or edit the implement offset values on the Offset screen:
a.
Touch the desired offset or value to edit.
b.
Use the on-screen keypad to enter the measured offset value in inches [centimeters].
Note:
The field computer will not recognize a negative value for any of the offset values. Be sure to enter
sure to enter positive values for each offset. All negative values entered will be reset to ‘0.’
4.
Touch the Next icon to complete the trailed implement configuration.
Trailed Implement with Tow Between Setup
Note:
The following instructions apply to
implement configurations such as air
seeders with the air cart towed in between
the seed drill and the tractor. Refer to the
Trailed Implement Setup section on
page 145 to configure an implement pulled
directly behind the tractor such as a pull-type
sprayer, anhydrous tool bar, or planter.
1.
If the Tow Between option is selected as the
implement type, the Cart Dimensions screen will
display after the Tractor Offsets Setup screen.
2.
Review the following definitions of the offsets for the
trailed implement setup. These values are critical for
performance of the field computer and product or implement control system. Measure carefully and enter
the offset values as accurately as possible to help ensure the best results.
Hitch to Axle. The first value on the Cart Dimensions screen should be measured from the tractor hitch pin to
the air cart pivot point, usually the center of the air cart axle.
Note:
If used with a four wheel air cart, the hitch to axle measurement may need to be adjusted to
provide accurate trailed implement mapping.
Measure the value parallel to the direction of travel.
Axle to Hitch. The second value on the Cart Dimensions screen is the measurement from the pivot point to
the hitch at the back of the air cart. When the two measurements on the Cart Dimensions screen are added
together, the value should equal the overall length of the air cart from the tractor hitch pin to the rear hitch.
Measure the value parallel to the direction of travel.
3.
To enter or edit the implement offset values on the Cart Dimensions screen:
a.
Touch the desired offset or value to edit.
b.
Use the on-screen keypad to enter the measured offset value in inches [centimeters].
Note:
The field computer will not recognize a negative value for any of the offset values. Be sure to enter
sure to enter positive values for each offset. All negative values entered will be reset to ‘0.’