Raven Envizio Pro, Инструкция по установке и эксплуатации

Страница: 179 / 287

Chapter 9
164 Envizio Pro™ and Envizio Pro II® Installation and Operation Manual
AccuBoom™ Setup
Prior to using the AccuBoom feature of the field computer, the AccuBoom node must be programmed for each
product. To configure the AccuBoom feature from the Home screen:
1.
Touch the Tools Menu icon.
2.
Select the Product Control icon from the System menu.
3.
Touch the AccuBoom button to display the AccuBoom Configuration screen.
Note:
If the Function Disabled screen appears when the AccuBoom icon is selected, troubleshoot the
AccuBoom node. See the CAN Troubleshooting section in Chapter 4, CAN Networking and
Diagnostics or Chapter 11, Troubleshooting, for help troubleshooting the AccuBoom node.
The following options are available on the AccuBoom Configuration screen for each available control channel
on the CANbus system. Touch the cycle product icon in the upper, right corner of the screen to cycle to the next
available control channel and configure the AccuBoom control feature for the next product controlled with the
field computer.
On Override
Touch the On-Override button and use the up or down arrows to increase or decrease the override time for the
AccuBoom feature.
Note:
The Override Sec value is not used if a SwitchPro or CAN switch box is installed on the CANbus.
The On Override feature is useful when backing into corners during boundary spraying, to begin
applying product from a complete stop, or to apply additional product to specific area of a field.
To enable the override during an AccuBoom enabled job:
1.
Toggle the ‘Master’ on the Raven CAN Switch Box to the Override position.
2.
The override timer will display a countdown for the override time in the switch box icon location. When the
override time expires, the switch box icon will return.