Orthofix CONTOURS PHP, Инструкция

Страница: 9 / 176

Procedure:
I.
Wearing protective equipment, fill the receptacle with sufficient disinfectant solution to ensure complete
immersion of the item.
II. Carefully immerse all components in the solution in order to displace trapped air; it is important to ensure that
the cleaning solution reached all surfaces, including those of cannulated devices.
III. Leave the items for the time required (3 hours with 3% Hydrogen Peroxide).
IV. Remove the items from the solution and drain.
V. Remove any residue with a brush in running water.
VI. Soak in sterile distilled water to remove traces of hard water.
VII. Remove item from rinse water and drain.
VIII. Carefully hand-dry using absorbent, non-shedding cloth or industrial hot hair dryer, or place in a drying cabinet.
IX.
Complete the necessary documentation.
X. Proceed with sterilization.
DISINFECTION PROCEDURE (AUTOMATIC)
Equipment required:
I.
A thermal washer-disinfector, cabinet or continuous process type.
II. A sufficient number of racks for stacking items to be processed.
III. A compatible disinfectant and rinse aid. Disinfectants with fluoride, chloride, bromide, iodide, or
hydroxyl ions [free halogen ions or sodium hydroxide] must not be used; Orthofix recommends
use of 0,5% phenolic disinfectant solution at 80°C (176°F). The validated cycle time is 80 minutes.
IV. A drainage surface.
V. A clean, disposable, absorbent, non-shedding cloth or mechanical drying facility.
Procedure:
I.
Ensure the washer-disinfector and all services are operational.
II. Wear protective equipment, load the rack/machine ensuring that the loading configuration does not impede the
cleansing process.
III. Select and start a cycle according to the recommendation of the washer manufacturer. On completion on the cycle,
ensure that all stages and parameters have been achieved; remove the load and visually check and inspect the
cleanliness of the item, drain off excessive water and dry if necessary.
IV. Complete the documentation.
V. Proceed with sterilization.
DISINFECTION PROCEDURE (ULTRASOUND)
Equipment required:
I.
An ultrasonic washer with lid which will hold enough liquid so that the items of equipment to be cleaned can be
fully immersed.
II. A sufficient number of supporting racks or trays for stacking items to be processed.
III. A timing device.
IV. A compatible water-detergent solution at dilution and temperature, recommended by manufacturer.
V. A clean, disposable, absorbent, non-shedding cloth or mechanical drying facility.
Procedure:
I.
Ensure the ultrasonic washer is clean and dry prior to use.
II. Wear protective equipment, fill the fluid reservoir with sufficient water/disinfectant to ensure complete immersion of items.
Disinfectants with fluoride, chloride, bromide, iodide, or hydroxyl ions [free halogen ions or
9