Omron NT - SUPPORT TOOL FOR WINDOWS V4, Руководство по эксплуатации

Страница: 492 / 573

Appendix A
Data Conversion
483
Difference
V2 or later models: New device monitor screens available.
Other models: Device monitor screens are not supported.
Conversion result, error message and corrective action
Status before
Conversion
Status after
Conversion
Error Message Corrective Action
With a V2 or later
model, a touch
switch of switch
screen type is
created with switch
screen number be-
ing 9023 (device
monitor screen) With a model earlier
than V2, touch
switch will be dis-
carded, because
switch screen num-
ber 9023 is not sup-
ported [E]
Invalid screen num-
ber in Touch Switch
(Switch Screen). None
In the case of Bit Memory Table, it will be reset based on the following table.
Default Screen
Number
PT-Models
0 NT30, NT30C, NT620C/625C, NT620S
1 NT20S, NT21, NT31, NT31C, NT31C-V1,
NT31C-V1 (System Ver 2.1), NT31-V1
NT31-V1 (System Ver 2.1), NT600S, NT631, NT631C,
NT631C-V1, NT631C-V1 (System Ver 2.1) NT631-V1,
NT631-V1 (System Ver 2.1)
NT20/30/620-compatible Mode
For the NT21 and the NT31, NT31C, NT631 and NT631C with “-V2” or “-V3”
NT20/30/620-compatible Mode can be set. Using this mode requires less modifi-
cation of screen data and programs, and is easier following conversion of screen
data between the NT21 and NT20S, and between V2 models and NT30, NT30C,
NT620S, NT620C, and NT625C.
If NT20/30/620-compatible mode is used, the functions of the NT21, NT31,
NT31C, NT631 and NT631C with “-V2” or “-V3” will differ as described below. For
details of the each function, refer to the NT21/31/631 Series Reference Manual
(V069-E1-
).
Reference: Except for the following points, the NT21, NT31, NT31C, NT631, and
NT631C-V2/V3 functions can be used as they are in NT20/30/620-compatible
mode.
When trying to convert the screen data from NT30, NT30C, NT620S, NT620C
or NT625C to NT31, NT31C, NT631 or NT631C with “-V2” or “-V3” or from the
NT20S to the NT21, NT20/30/620-compatible mode will be automatically ON
in the default status. If you do not want to use NT20/30/620-compatible mode,
disable the NT20/30/620-compatible mode ([PT Configuration] – [PT Type]).
NT20/30/620-compatible mode can be set only when NT21, NT31, NT31C,
NT631 or NT631C-V2/V3 is selected as a PT Model. In NT20/30/620-compat-
ible mode, the following points will be the same as for the NT30/620 series.
Image/library can be inserted into a lamp/touch switch label or a character
string.
Image/library code
Word configuration of PT control/notify area