Omron NT - SUPPORT TOOL FOR WINDOWS V4, Руководство по эксплуатации

Страница: 219 / 573

6-7 Section Character String Display
206
Example
Specifying memory table address 2
TOOL
Character string
memory table
(String table)
Indirect designation Direct designation
Display
TOOL
1
2
3
4
5
Character string
memory table
(String table)
Display
TOOL
1
2
3
4
5
TOOL
The contents of the specified
memory table entry are displayed.
The contents of the specified numeral
memory table entry are treated as the
table entry address reference value and
the contents of the referenced memory
table are displayed.
Numeral
memory table
1
2
3
4
5
5
Indirect designation is possible only in the following cases. Do not apply for other
cases.
When C200H I/F unit is used.
When the NT20, NT21, NT30, NT30C, NT31, NT31C, NT620S, NT620C,
NT625C, NT631, or NT631C is used.
When an NT20S or NT600S that uses direct connection ver. 5 is used.
With conventional models, up to 50 indirect designation settings can be made
per screen, including both numeral display and (character) string display.
If the value set for [Length] (the number of digits to be displayed) is smaller than
the number of characters in the specified character string memory table entry
(string table), the specified number of characters is displayed from the first
character of the (character) string. The remaining characters are not dis-
played.
To display mark data or image data, specify the address of the mark data or
image data as shown below.
Note that image data cannot be inserted into a (character) string when using
the NT11S/NT11, NT20, NT20S, NT21 (20/30/620 mode off), NT31, NT31C,
NT600S, NT631, NT631C, NT31/C-V2 (20/30/620 mode off), and
NT631/C-V2 (20/30/620 mode off).
ABC
Display Setting
ABC<!FFFE>
Mark data at code FFFE
Reference: When there are no string to show, string input will be invisible.
Therefore, with Support Tool, dotted-line frame is displayed in character fore-
ground color enclosing string input.
(This frame will not be displayed on PT.)
This frame can not be set to off. However, the dotted-line frame can be set to ON
and OFF when printing screen image (refer to page 425).