Mitsubishi Electric MR-J4-100B(-RJ), Инструкция по эксплуатации

Страница: 683 / 706

APPENDIX
App. - 70
App. 15.3 Selection example of wires
POINT
Selection conditions of wire size are as follows.
Construction condition: Single wire set in midair
Wiring length: 30 m or shorter
The following diagram shows the wires used for wiring. Use the wires given in this section or equivalent.
(1) Example of selecting the wire sizes
Use the 600 V grade heat-resistant polyvinyl chloride insulated wire (HIV wire) for wiring. The following
shows the wire size selection example.
Servo amplifier
Wire [mm 2 ] (Note 1)
L1/L2/L3/N-/ L11/L21
MR-J4-10B-RJ
2 (AWG 14)
1.25 to 2
(AWG 16 to 14)
MR-J4-20B-RJ
MR-J4-40B-RJ
MR-J4-60B-RJ
MR-J4-70B-RJ
MR-J4-100B-RJ
MR-J4-200B-RJ
MR-J4-350B-RJ
3.5 (AWG 12)
MR-J4-500B-RJ (Note 2) 5.5 (AWG 10): a
1.25 (AWG 16): a
2 (AWG 14): d
MR-J4-700B-RJ (Note 2) 8 (AWG 8): b
MR-J4-11KB-RJ (Note 2) 14 (AWG 6): e
1.25 (AWG 16): c
2 (AWG 14): c
MR-J4-15KB-RJ (Note 2) 22 (AWG 4): f
MR-J4-22KB-RJ (Note 2) 38 (AWG 2): g
Note 1. Alphabets in the table indicate crimping tools. For crimp terminals and applicable
tools, refer to (2) in this section.
2. To connect these models to a terminal block, be sure to use the screws that
come with the terminal block.
(2) Selection example of crimp terminals
Symbol
Servo amplifier-side crimp terminal
(Note 2)
Crimp terminal
Applicable tool
Manufacturer
Body Head Dice
a FVD5.5-4 YNT-1210S
JST
b (Note 1) 8-4NS YHT-8S
c FVD2-4
YNT-1614
d FVD2-M3
e FVD14-6 YF-1 YNE-38
DH-122
DH-112
f FVD22-6 YF-1 YNE-38
DH-123
DH-113
g FVD38-8 YF-1 YNE-38
DH-124
DH-114
Note 1. Coat the crimping part with an insulation tube.
2. Some crimp terminals may not be mounted depending on their sizes. Make sure to use the
recommended ones or equivalent ones.