Lucent Technologies OptiStar EdgeSwitch, Руководство пользователя

Страница: 34 / 330

1 - 8
Lucent Technologies
365-575-925R1.5
Issue 1, April 2002
1.4.2 Power Module
The OptiStar EdgeSwitch includes two hot swappable, redundant AC Power Modules, which operate in load
sharing mode. For additional protection, plug Power Modules into two separate power sources, to allow for a
power circuit failure without affecting the performance of the OptiStar EdgeSwitch. Each Power Module has an
on/off switch, and a bi-colored LED that shows the status. Each Power Module provides 200 Watts and operates
at 90-132/180-264 Volts AC @ 47-63 Hz, auto-ranging.
1.4.2.1 LED Indicators
Each power module has a power on/off switch, and a bi-colored LED that shows the status. The following table
describes how to interpret the LEDs on the front of the Power Module.
If one of the Power modules fails, a trap will be sent to the designated management station(s).
1.4.3 Fibre Channel Over IP (FCIP) Network Module
The OptiStar EdgeSwitch Fibre Channel over IP (FCIP) Network Module extends storage networks across the
IP WAN. The FCIP Network Module interoperates with industry-leading Fibre Channel-based storage
technologies including fabric switches, hubs, host bus adapters and storage systems.
One FCIP Network Module contains an integrated two-port Fibre Channel switch engine, providing two 1 Gbps
Fibre Channel switch ports . Fibre Channel frames can be switched between Fibre Channel ports within the same
OptiStar EdgeSwitch unit, or may be tunneled over OC-12c/STM-4c, OC-48c/STM-16c, and/or Gigabit
Ethernet WAN links. This dual port module is hot swappable and is plugged into the backplane that connects it
to the OptiStar EdgeSwitch switch fabric. Each OptiStar EdgeSwitch FCIP Network Module can communicate
to up to 239 other OptiStar EdgeSwitch FCIP Network Modules. The number is limited by the available Fibre
Channel domains and some addresses are reserved. The domain number is an 8-bit hexadecimal value, ranging
from x01-xEF. Each FCIP Network Module must be assigned an IP address, referred to in this document as the
FCIP Network Module IP address.
The FCIP Network Modules uses GBICs for the physical interface. The GBICs are hot swappable and are
available in 850nm multimode fiber, 1310nm single-mode fiber, and HSSDC or DB9 copper versions.
See
Section 2.3.2 for more information about FCIP Network Module GBIC options.
LED Color LED Indicates
Green AC power on
Red
AC power off or power module malfunctioning.
Red status is valid only if one of the power modules is on.
No light Unit is powered off