Lucent Technologies OptiStar EdgeSwitch, Руководство пользователя

Страница: 81 / 330

OptiStar EdgeSwitch Configuration
365-575-925R1.5
Lucent Technologies
4 - 1 9
Issue 1, April 2002
Continue adding each port to the Port Group one at a time until all ports are added.
Example:
To assign Module 2/Port 1 to Port Group 3, complete the prompts as follows:
Enter Module Number (1-4) : 2
Enter Port Number (1-2) : 1
Enter Port Group (1-8)
: 3
Step 5
To verify that the Port Mapping has been configured correctly, return to the Port Mapping Table
under
[1] Operational Information & Status
Æ Æ Æ Æ
[3] Port Mapping
to view the current Port
Mapping configuration.
Example:
After entering all the ports in the example configuration, the Port Mapping Table should
look like the following example:
Module Number Port Number Port Group
1 1 1
1 2 2
2 1 3
2 2 3
3 1 3
3 2 6
4 1 7
4 2 8
Step 6
Now you are ready to assign IP addresses and the subnet mask. To configure the IP address and
subnet mask for each interface (switching port) on the OptiStar EdgeSwitch, start at the main menu,
then follow the path:
[3] Configuration
Æ Æ Æ Æ
[4] IP Parameters
Æ Æ Æ Æ
[3] Set Switching Port IP Address & Mask
Step 7
You should now see the
Set switching port IP Address & Mask
menu, as follows:
Set Switching Port IP Address and MASK
F1 (Main Menu) F2 or .. (Previous Menu) F3 (Exit)
[1] Set Switching Port IP Address
[2] Set Switching Port Subnet Mask
Enter your Choice >
Under Option
[1] Set Switching Port IP Address
, the following prompts will be displayed in
succession:
Enter Switching Module Number (1-4) :
Enter Switching Port Number (1-2) :
Enter Switching Port IP Address :