Lucent Technologies OptiStar EdgeSwitch, Руководство пользователя

Страница: 79 / 330

OptiStar EdgeSwitch Configuration
365-575-925R1.5
Lucent Technologies
4 - 1 7
Issue 1, April 2002
Step 2
You should now see the
Set switching port IP Address & Mask
menu, as follows:
Set Switching Port IP Address and MASK
F1 (Main Menu) F2 or .. (Previous Menu) F3 (Exit)
[1] Set Switching Port IP Address
[2] Set Switching Port Subnet Mask
Enter your Choice >
If you select
[1] Set Switching Port IP Address
, the following prompts will be displayed in
succession:
Enter Switching Module Number (1-4) :
Enter Switching Port Number (1-2) :
Enter Switching Port IP Address :
If you select
[2] Set Switching Port Subnet Mask
, the following prompts will be displayed in
succession:
Enter Switching Module Number (1-4) :
Enter Switching Port Number (1-2) :
Enter Switching Port Subnet Mask :
Configure the IP address(es) and subnet mask(s) for each interface (switching port) on the OptiStar
EdgeSwitch. Refer to the diagram on
Slot Numbering in Section 3.4.1 for help in determining correct
module and port numbers. Empty slots on the OptiStar EdgeSwitch do not need to be configured.
Step 3
To verify that the you have entered the IP addresses correctly, you may view the Switching Ports IP
Address Table. From the main menu follow the path:
[1] Operational Information & Status
→
→ →
→
[4] IP Parameters
→
→ →
→
[3] Switching Ports IP Address
Step 4
Once all of the IP addresses and subnet masks are entered, continue to Section 4.6, entitled
“
Setting
up a Static Route and Checking IP Connectivity
”.
4.5.2 How to Set Up IP Addresses on the OptiStar EdgeSwitch with Bridging
Grouping may be done only on Gigabit Ethernet (GbE) ports. Ports that are in the same group allow for Layer 2
switching between those ports. VLAN tags can be passed transparently between GbE ports if they are in the same
group. If ports are in different groups, then Layer 3 switching is performed by default. Note that when data passes to
or from an OC-12 or an OC-48 port, Layer 3 switching is automatically performed regardless of port grouping.
Thus, port grouping is only meaningful for Gigabit Ethernet ports.
The bridging is set up via the Port Mapping Table (Menu path: [3] Configuration
Æ
[5] Port Mapping).