Lucent Technologies OptiStar EdgeSwitch, Руководство пользователя

Страница: 200 / 330

6 - 2 2
Lucent Technologies
365-575-925R1.5
Issue 1, April 2002
The following shows how to interpret the GBIC LEDs on the front of the FCIP Network Module, as well as
how the LED status corresponds to the enumerated Module values from the legend above:
6.1.4.3 Set Port Type
Menu Path:
1) config
→
4) port
→
3) type
Shortcut Command:
At the root menu, type
config port type #,
where
#
is the number representing the desired port type (see
available options in the Description section below).
Description:
Once this menu item is selected, the following list of options will be displayed, followed by the existing port
type in brackets. In this example, the current port type is [5] autoDetect.
Note : Option [4] stealthLoop is not
supported on the OptiStar EdgeSwitch.
However, even though Option [4] stealthLoop may not be set as the
selected port type, in certain cases the FCIP port will report itself as a stealthLoop port type. For example, when
using a private JBOD device like the SUN A5200 JBOD with the FCIP module in fabric public / private mode
and the FCIP port type set to G port, the FCIP port will report itself as a Stealth Loop port type when the JBOD
is connected.
[1] fPort
[2] flPort
[3] ePort
[4] stealthLoop
[5] autoDetect
[6] gPort
Type [5] =
Press the <
Enter
> key to keep the existing port type, or enter a new type after the equal sign, then press the
<
Enter
> key. The display will show OK, indicating the new port type has been accepted.
Please refer to the following table for detailed definitions of each port type.
Link/Active LED
(GREEN)
Isolation LED
(AMBER)
Status
Off
Off No GBIC module inserted. Module value 9 .
Off
Solid
Port is bypassed; the GBIC may have a
transmitter (Tx) fault.
Module value 1 .
Solid Off
GBIC is inserted and good; communication is
established. Module values 2 through 8 .
Solid Solid
GBIC is inserted and good, but no link is
established.
Flashing Flashing
Port has been reset and did not complete
start-up sequence -or- Beacon Port Mode
Flashing Off Data is being transmitted or received