Lucent Technologies OptiStar EdgeSwitch, Руководство пользователя

Страница: 57 / 330

Hardware Installation
365-575-925R1.5
Lucent Technologies
3 - 7
Issue 1, April 2002
Always place Network Modules component side up on an antistatic surface or in a static-shielding bag. Handle
Network Modules only by the edges and avoid touching the board. To install a Module, slowly insert it into the
slot making sure that the edges of the Module line up with the guides on the chassis. The Module is seated when
the front panel of the Module is flush with the front panel of the OptiStar EdgeSwitch. Ensure that the release
levers on the front edges of the modules are in a closed position (pressed against the front panel). Secure with
thumbscrews.
Figure 3-5: Installing a Network Module on the OptiStar EdgeSwitch
Any vacant slot in the OptiStar EdgeSwitch must be covered with a blank filler panel to ensure proper flow of
cooling air through the power modules, to protect the unit from dust or other particulate matter and to satisfy
EMI compliance requirements
.
Figure 3-6: Installing a Blank Filler Panel on the OptiStar EdgeSwitch
3.4.3 Installing the GBIC Modules
Both the FCIP Network Modules and the Gigabit Ethernet Network Modules use GBICs for the physical
interface. For a list of approved GBICs for the FCIP and Gigabit Ethernet Network Modules
see Section 2.3.2 .
See Section 2.4 for cable guidelines for the GBIC Modules.
Figure 3-7: GBIC Insertion and Removal