Lucent Technologies OptiStar EdgeSwitch, Руководство пользователя

Страница: 187 / 330

Detailed FCIP Network Module CLI Reference Guide
365-575-925R1.5
Lucent Technologies
6 - 9
Issue 1, April 2002
6.1.3.2 Set Port Zoning Parameters
Menu Path:
1) config
→
3) zone
→
2) port
Shortcut Command:
At the root menu, type
config zone port
Description:
This menu item and the related sub menus are not supported on the OptiStar EdgeSwitch.
6.1.3.3 Set WWN Zoning Parameters
Menu Path:
1) config
→
3) zone
→
3) wwn
Shortcut Command:
At the root menu, type
config zone wwn
Description:
When menu item
3) wwn – Set WWN Zoning Parameters
is selected, the existing settings are displayed (for help
see Section 6.1.3.3.1 ) followed by the sub-menu shown below:
config/zone/wwn
menu
1)
back - Go back
2)
show - Show other zoning information (For help, go to Section 6.1.3.3.2 on page 6-10 )
3)
state - Set default state (For help, go to Section 6.1.3.3.3 on page 6-10 )
4)
zoneset - Configure WWN Zone sets (For help, go to Section 6.1.3.3.4 on page 6-10 )
5)
zone - Configure WWN Zones (For help, go to Section 6.1.3.3.5 on page 6-15 )
Enter a number from the
config/zone/wwn
menu to go to the corresponding category.
6.1.3.3.1 General Description
WWN (World Wide Name) zoning uses the World Wide N_Port_Names (WWPNs) from the name server in the
switches to either allow or block access to particular WWNs in the fabric. Lucent’s WWN zoning configuration
complies with T-11 standards (SW-2 and GS-3).For a detailed description and tutorial on setting up WWN
Zoning on the OptiStar EdgeSwitch,
see Section 4.10 .