Lucent Technologies OptiStar EdgeSwitch, Руководство пользователя

Страница: 278 / 330

8 - 4
Lucent Technologies
365-575-925R1.5
Issue 1, April 2002
Problem Possible Solutions
A Network Module becomes faulty
•
Replace the Network Module following the steps in
Section 7.2.1, entitled “Network Module
Replacement”.
Not able to log in to the FCIP Network
Module.
•
Ensure that a local FCIP Network Module IP address
has been assigned to the FCIP Network Module.
Also, ensure that the FCIP Network Module IP
address you assigned is in the same subnet as Port
1 of the FCIP Network Module. For help please refer
to
Section 4.8, entitled “Configuring an FCIP Network
Module” .
The FCIP Network Module booted from
the wrong firmware image file. For backup purposes, the FCIP Network Module has
two separate locations to store complete copies of its
firmware. These locations are known as Image 1 and
Image 2. If the FCIP Network Module cannot boot
from one of these images, it can be set to boot from
the other. Currently, there are three ways to change
the boot image for the FCIP Network Module:
1. Upload new firmware to the FCIP Network
Module. For help, see Section 7.3.2, entitled
“Installing New FCIP Network Module Firmware”.
2. Manually select the firmware boot image. For
help, see Section7.3.2.1, entitled “How to
Manually Select the FCIP Network Module
Firmware Boot Image”.
3. A single firmware image fails to boot twice in a
row. If the firmware image selected as the
Power-up Image fails to boot up twice in a row
the FCIP Network Module will automatically
change the Power-up Image to the other
firmware image file. In this way a corrupted or
non-functional firmware image file can be
replaced while minimizing the EdgeSwitch
downtime.
Both LEDs on the FCIP Network Module
(green and amber) are flashing.
•
This condition may indicate the Beacon Port Mode
has been turned on. Please see
Section 6.5.3.3 for
more help.
•
If Beacon Port Mode has not been enabled, ensure
that a local FCIP Network Module IP address has
been assigned to the FCIP Network Module. Also,
ensure that the FCIP Network Module IP address you
assigned is in the same subnet as Port 1 of the FCIP
Network Module. For help please refer to the
Section
4.8, entitled “Configuring an FCIP Network Module” .