Lucent Technologies OptiStar EdgeSwitch, Руководство пользователя

Страница: 99 / 330

OptiStar EdgeSwitch Configuration
365-575-925R1.5
Lucent Technologies
4 - 3 7
Issue 1, April 2002
The
Local FCIP Network Module IP Parameters Table
is a read-only table that displays the
currently configured FCIP Network Module IP address and subnet mask information for each slot on
the local OptiStar EdgeSwitch.
See Section 5.1.10.1, entitled “Local FCIP Network Module IP
Parameters” for more help on interpreting this table.
4.8.2 How to Access the CLI for an FCIP Network Module
Step 1
Ensure that the OptiStar EdgeSwitch is configured correctly. If using Telnet, ensure that the PC NIC
card has been configured to be on the same subnet as the OptiStar EdgeSwitch 10/100BaseT port (
see
Section 4.5 ).
Step 2
Ensure that the FCIP Network Module has been configured correctly ( see Section 4.8.1 ).
Step 3
Ensure that the FCIP Network Module is enabled. From the main menu, follow the path:
[5] Utilities
→ → → →
[5] Local FCIP Network Module State
For help interpreting the
Local FCIP Network Module State
table, see Section 5.5.5 .
Step 4
Next, to access the CLI for the FCIP Network Module, determine how you are logged in to the
OptiStar EdgeSwitch CLI (either via serial link or telnet;
see Section 4.2.1.1 for additional help). If
you are logged on to the OptiStar EdgeSwitch CLI through the serial link, you will access the FCIP
Network Module CLI through the Serial Proxy menu item. From the OptiStar EdgeSwitch main
menu, follow the path:
[4] Administration
→ → → →
[4] FCIP Network Module CLI – Serial Proxy
If you are logged on to the OptiStar EdgeSwitch CLI through telnet, you will access the FCIP
Network Module CLI through the Telnet Proxy menu item. From the main menu, follow the path:
[4] Administration
→
→ →
→
[5] FCIP Network Module CLI – Telnet Proxy
Step 5
At the prompt, enter the number of the specific FCIP Network Module (slot) that you would like to
access.
Step 6
At the next prompt, enter the password. If a specific password has not been defined, the default
password is ‘
manage
’. Please go directly to the next section (Section 4.8.3) for help on setting
passwords for the FCIP Network Module CLI.
Step 7
You should now see the FCIP Network Module CLI Root Menu, as follows:
1) config - Configure switch settings
2) reset - Reset switch (Example: >reset)
3) show - Show device information
4) firmware - Access firmware options
5) diagnostics - Access diagnostic features