Lucent Technologies OptiStar EdgeSwitch, Руководство пользователя

Страница: 65 / 330

OptiStar EdgeSwitch Configuration
365-575-925R1.5
Lucent Technologies
4 - 3
Issue 1, April 2002
If the boot firmware fails to find the runtime file (i.e., the file is not present in the FLASH) the following will
occur:
•
If the current configuration parameters are valid, TFTP is initiated using the TFTP parameters from the
current configuration.
•
Otherwise, the Boot firmware will get the TFTP server parameters using BOOTP.
If BOOTP fails, then the user will be prompted for the TFTP parameters and 10/100BaseT parameters through
the BootUp Menu
(see Section 4.1.2, entitled “Manual BootUp Process”) .
4.1.2 Manual BootUp Process
During bootup of the OptiStar EdgeSwitch, you should see the following message:
“Press any key to enter BootUp Menu”
If any key is pressed during POST or before the 7-second countdown ends
, the OptiStar EdgeSwitch BootUp
Menu will be displayed. Pressing the key causes the boot firmware to load the runtime firmware from the
FLASH and write it to SDRAM. The BootUp Menu should be used the first time a user is configuring the
OptiStar EdgeSwitch to enter the initial parameters.
4.1.2.1 BootUp Menu
OptiStar EdgeSwitch BootUp Menu:
[1] Status and Information
[2] Configuration
[3] Download Firmware
[4] Invoke Firmware
[5] Reset OptiStar EdgeSwitch
[6] Clear EdgeSwitch Configuration
If this is the first time you are starting up the OptiStar EdgeSwitch, follow these steps:
Step 1
Follow the menu path
[2] Configuration
Æ
Æ Æ
Æ
[1]Configure Boot Parameters
Æ
Æ Æ
Æ
[1] 10/100BaseT
Port IP Address
to enter the 10/100BaseT IP Address.
Step 2
Next, from the
Configure Boot Parameters
sub-menu, select menu option
[2] 10/100BaseT Port
Subnet Mask
to enter the 10/100BaseT Subnet Mask.
Step 3
Return to the Main
BootUp Menu
by entering
..
Step 4
From the
BootUp Menu
, select menu option
[5] Reset OptiStar EdgeSwitch
to reboot the OptiStar
EdgeSwitch.
Step 5
Once the system has booted, verify that the LED indicator next to the 10/100BaseT port indicates the
proper status.