Lucent Technologies OptiStar EdgeSwitch, Руководство пользователя

Страница: 285 / 330

Appendices
365-575-925R1.5
Lucent Technologies
A P - 3
Issue 1, April 2002
14
Login in as “optistar” and then enter a
new password for Admin User.
[4] Administration
→
[1] Authentication Info...
→
[2] Modify Administrator…
Section 5.4.1.2
15
Reboot/Reset the OptiStar
EdgeSwitch.
[3] Configuration
→
[2] System Information
→
[7] Reset OptiStar…
Section 5.3.2.7
16
Allow the OptiStar EdgeSwitch to
fully boot (this time allow it to
AutoBoot instead of getting in to the
BootUp Menu).
NA Section 4.1.1
17
Login in as Admin User (use “optistar”
if not changed in step 12).
NA Section 4.3.1
18
Ping the 10/100 port from a PC on the
same subnet.
NA NA
19
Ping your PC from the OptiStar
EdgeSwitch.
[5] Utilities
Æ
[1] Ping Utility
Section 5.5.1
20
Set up SNMP management:
- Add NMS Entry
- Modify Community Name
- Modify Trap Admin Status
[4] Administration
Æ
[3] SNMP Configuration
Æ
then:
[2] Add NMS Entry
[5] Modify Community…
[6] Modify Trap Admin…
Section 5.4.3
21
Add all authorized users the system.
The maximum number of users that
may be assigned is 8 (not including the
super user).
[4] Administration
Æ
[6] User Management
Æ
[1] Add User
Section 4.4
22
Assign IP addresses/Subnet Masks to
all other ports.
[3] Configuration
Æ
[4] IP Parameters
Æ
[3] Set switching port
IP address & Mask…
Section 5.3.4.3
23
Assign an IP address to each FCIP
Network Module.
[3] Configuration
→
[9] FCIP Network…
→
[1] Add Local FCIP…
Section 5.3.9.1
24
Reboot the OptiStar EdgeSwitch for
changes made in
Steps 22
and
23
to
take effect.
[[3] Configuration
→
[2] System Information
→
[7] Reset OptiStar…
Section 5.3.2.7
25
Login to a specific FCIP Network
Module CLI via Telnet Proxy or Serial
Proxy as appropriate(password =
”manage”).
[4] Administration
Æ
[4] … Serial Proxy
Æ
Enter the FCIP Net…
[5] … Telnet Proxy
Æ
Enter the FCIP Net…
Section 5.4.4
26
Assign new passwords for the FCIP
Network Module.
1) config
Æ
6) password
Æ
then:
2) monitor
3) manage
Section 6.1.6
27
Repeat
Steps 25
and
26
for any
additional FCIP network modules.
NA NA