Lucent Technologies OptiStar EdgeSwitch, Руководство пользователя

Страница: 112 / 330

4 - 5 0
Lucent Technologies
365-575-925R1.5
Issue 1, April 2002
Example:
(config/zone/wwn/zoneset)>activate “Backup”
At this command, the switch activates the Zone Set on itself then attempts to force the Zone set onto
other switches in the fabric (Zone Merge). Once you have entered this command, press the down
arrow key to scroll to a message that states “
depress any key to cancel
”.
WARNING
: Striking any
key at this point, including the Enter key, will cancel the activate command.
If the
activate
command is completed successfully (<15 seconds), the message “
OK
” should be
displayed. Once a Zone Set is activated, it is stored in the temporary memory of all switches in the
fabric. If the attempt is unsuccessful, error messages appear, event messages are logged, and an
isolated E_Port condition occurs, as indicated by a blinking-green LED and solid-amber LED
combination on the affected port. For more help on activating Zone Sets,
see Section 6.1.3.3.4.7 . For
a description of the Zone Merge operation, see Section 4.10.1.5 .
Step 7
To verify that the Zone Set is enforced, type the following command from the
zoneset
menu:
(config/zone/wwn/zoneset)>:
senf
or from the Root Menu type:
config zone wwn show
4.11 Exporting/Importing the OptiStar EdgeSwitch Configuration
Once you have configured all of the critical parameters on your OptiStar EdgeSwitch, it is recommended that
you save the current configuration to a file using the Configuration File Export utility. This file may then be
imported back into an OptiStar EdgeSwitch at a later time using the Configuration File Import utility. The ability
to save and import specific OptiStar EdgeSwitch configurations is extremely useful in the following scenarios:
•
Upgrading to a new firmware release
•
Configuring multiple OptiStar EdgeSwitches in a network
•
Reverting to a previous configuration
•
Recovering from an unexpected failure in which parameters were either changed or reset to default
values
The following two tutorials describe how to create and export a configuration file, as well as import a file with
configuration settings into an OptiStar EdgeSwitch.
4.11.1 Export Configuration File
To export the current OptiStar EdgeSwitch configuration to a binary file, complete the following steps:.
Step 1
First ensure that all desired configuration parameters for the OptiStar EdgeSwitch have been defined.
Step 2
Before the current configuration can be exported as a file to an FTP Server, several parameters must
be set on the OptiStar EdgeSwitch. The next steps will guide you in setting up the following
parameters, which are all accessible from the
EdgeSwitch Configuration Import/Export
sub-menu:
a. The IP address of the FTP Server to which the EdgeSwitch Configuration file will be saved.
b. The directory name (if any) on the FTP Server within which the file will be saved.
c. The file name that will be given to the EdgeSwitch Configuration file.