Lucent Technologies OptiStar EdgeSwitch, Руководство пользователя

Страница: 193 / 330

Detailed FCIP Network Module CLI Reference Guide
365-575-925R1.5
Lucent Technologies
6 - 1 5
Issue 1, April 2002
down arrow key to scroll to a message that states “
depress any key to cancel
”.
WARNING
: Striking any key at
this point, including the Enter key, will cancel the
deactivate
command.
When the current active zone set (or enforced zone set) is deactivated, no zone set will be enforced in the fabric
until a new one is assigned using the
Activate Zone Set
command ( see Section 6.1.3.3.4.7 ).
If the
deactivate
command has been issued and a time out occurs, remove the FC switch (or FCIP Network
Module) from the fabric and then reattempt the
deactivate
command.
6.1.3.3.5 Configure WWN Zones
Menu Path:
1) config
→
3) zone
→
3) wwn
→ → → →
5) zone
Shortcut Command:
At the root menu, type
config zone wwn zone
Description:
When menu item
5) zone – Configure WWN Zones
is selected, the existing settings are displayed (for help see
Section 6.1.3.3.5.1 ) followed by the sub-menu shown below:
config/zone/wwn/zone
menu
1)
back - Go back
2)
show - Show zones (For help, go to Section 6.1.3.3.5.2 on page 6-16 )
3)
zadd - Add zone (For help, go to Section 6.1.3.3.5.3 on page 6-16 )
4)
zdel - Delete zone (For help, go to Section 6.1.3.3.5.4 on page 6-16 )
5)
madd - Add member (For help, go to Section 6.1.3.3.5.5 on page 6-17 )
6)
mdel - Delete member (For help, go to Section 6.1.3.3.5.6 on page 6-18 )
7)
define - Define members within zones (For help, go to Section 6.1.3.3.5.7 on page 6-18 )
Enter a number from the
config/zone/wwn/zone
menu to go to the corresponding category.
6.1.3.3.5.1 General Description
When defining zones, object names (for new or existing Zone Sets, Zones, or Members) must be enclosed in
quotes when specified. While the command examples shown within the menu specify one or more object names
(an object being a Zone Set, Zone, or Member), you may enter just the command. If the required object names
are not specified when the command is entered, then you are prompted either for the desired name or for
selection of one or more objects from a list of those available.