Lucent Technologies OptiStar EdgeSwitch, Руководство пользователя

Страница: 103 / 330

OptiStar EdgeSwitch Configuration
365-575-925R1.5
Lucent Technologies
4 - 4 1
Issue 1, April 2002
Step 5
Next go to the CLI main menu for the second OptiStar EdgeSwitch and repeat steps (3) and (4) for
the second OptiStar EdgeSwitch.
Step 6
Next you are ready to set up routing between the two OptiStar EdgeSwitches. The routing can be set
up via static route entry or via one of the following protocols: RIP, OSPF, BGP4.
See Sections 4.6
and 4.7 for additional help.
Step 7
Now you are ready to boot up the OptiStar EdgeSwitches.
Booting Instructions:
Configure both OptiStar EdgeSwitches using the tutorials, then boot them separately without
connecting the cable. After both OptiStar EdgeSwitches come up successfully, connect the cable so
that link will be UP. Now wait for several moments so that the FCIP Network Modules can do the
tunnel negotiations. To check whether FCIP Network Modules established the tunnel successfully,
select the following option:
[1] Operational Information & Status
→ → → →
[10] FCIP Network Module Status
→ → → →
[3] FCIP Network
Module Connection Status
See Section 5.1.10.3, entitled “FCIP Network Module Connection Status” for help interpreting this
table. See Section 5.5.4, entitled “Local FCIP Network Module Domain
↔
IP Table” for additional
information.
4.9.1 Example FCIP Tunnel Configuration for 2 OptiStar EdgeSwitches
The following example configuration assumes a network with 2 OptiStar EdgeSwitches, each with one Gigabit
Ethernet Module and one FCIP Network Module. Let us assume the following configurations.
OptiStar EdgeSwitch A OptiStar EdgeSwitch B
Slot 1: Gigabit Ethernet Network Module Slot 1: Empty
Slot 2: FCIP Network Module Slot 2: Empty
Slot 3: Empty Slot 3: Gigabit Ethernet Network Module
Slot 4: Empty Slot 4: FCIP Network Module
Step 1
Configure the IP Addresses and Subnet Masks on OptiStar EdgeSwitch A
Using the tutorial in Section 4.8.1, assign the interface IP addresses and subnet masks for OptiStar
EdgeSwitch A as follows:
Port IP address Subnet Mask
1 192.168.3.100 255.255.255.0
2 192.168.4.100 255.255.255.0
3 192.168.5.100 255.255.255.0
4 192.168.6.100 255.255.255.0
5 0.0.0.0 0.0.0.0
6 0.0.0.0 0.0.0.0
7 0.0.0.0 0.0.0.0
8 0.0.0.0 0.0.0.0