Lucent Technologies OptiStar EdgeSwitch, Руководство пользователя

Страница: 186 / 330

6 - 8
Lucent Technologies
365-575-925R1.5
Issue 1, April 2002
6.1.2.7 Reset Fault LED
Menu Path:
1) config
→
2) event
→
7) reset_led
Shortcut Command:
At the root menu, type
config event reset_led
Description
This menu item is not supported on Release 1.2 of the OptiStar EdgeSwitch.
6.1.3 Set Zone Parameters
Menu Path:
1) config
→
3) zone
Shortcut Command:
At the root menu, type
config zone
Description:
When menu item
3) zone – Set zone parameters
is selected, the following sub menu will be displayed:
config/zone
menu
1) back
-
Go back
to the previous menu
2) port –
Set
port
zoning parameters (For help on this item, go to Section 6.1.3.2 on page 6-9 )
3) wwn
– Set
WWN
zoning parameters (For help on this item, go to Section 6.1.3.3 on page 6-9 )
Enter a number from the
config/zone
menu to go to the corresponding category.
6.1.3.1 General Description
Zoning is a fundamental technique for Storage Area Network (SAN) management that can be implemented in
several different ways. In all cases zoning serves to allow users access to the appropriate storage devices in
order to increase security, isolate elements of the SAN for interoperability or application reasons, and optimize
the flow of traffic over the network. The OptiStar EdgeSwitch uses WWN Zoning to enable the user to set up
logical groupings within the Fibre Channel SAN fabric. Port Zoning is not supported on the OptiStar
EdgeSwitch. For a detailed description and tutorial on setting up WWN Zoning on the OptiStar EdgeSwitch,
see
Section 4.10 .