JUMO AQUIS touch P 202580, Руководство по эксплуатации

Страница: 153 / 322

153
10 Configuration
10.16 Ethernet
The Ethernet settings must be requested from the administrator of the
network in which the device is installed.
Open: Device menu
r
Configuration
r
Ethernet
Configuration point Selection/
setting option
Explanation
Assign IP address Manual
Automatic manual: If no DHCP server is installed
or a dedicated IP configuration is desired and the
IP address configuration is known (e.g. from the
network administrator), the data can be entered
manually.
automatic: A DHCP server is installed
in the network. During power-up and booting,
the JUMO AQUIS touch P receives
the IP configuration from the DHCP server; the
IP configuration takes place automatically.
Manual IP address Valid IP address
a
IP configuration of the Ethernet optional board
Manual entry of known configuration data or au-
tomatic configuration by the DHCP server (see
configuration item "IP address assignment")
Subnet mask Valid subnet mask
a
Standard gateway Valid IP address
a
DNS server Valid IP address
a
Transfer rate Automatic
10 Mbit/s half duplex
10 Mbit/s full duplex
100 Mbit/s half duplex
100 Mbit/s full duplex Transmission speed (bit rate) and duplex mode
of the Ethernet optional board
This setting must match the setting of the
switch or router port to which
the JUMO AQUIS touch P is connected.
a
To enter an IP configuration manually for the JUMO AQUIS touch P, a valid available IP address in the
network must be known. Please contact your network administrator in this regard.
NOTE!
The Ethernet settings are entered in the online parameters in the JUMO PC
setup program.
The IP configuration of the device can also be changed from the PC if the PC
and device are connected via Ethernet. In this case, changing the IP address
or subnet mask can interrupt the PC-device connection.
v
See chapter 19.9.3 "Ethernet", page 295