JUMO AQUIS touch P 202580, Руководство по эксплуатации

Страница: 239 / 322

239
19 PC Setup Program
19.7 Connection to device
This chapter describes the various ways to establish a connection between the
JUMO PC setup program and the device. A connection is possible via:
•
LAN interface (HTTP or HTTP proxy)
• USB interface
An existing connection is a requirement for data transfer between the JUMO PC
setup program and system. In the menu bar, open:
Data Transfer
r
Establish Connection ...
19.7.1 Device connections list
The device connections list contains all devices for which a connection has been
configured. The user can add connections to new devices, change the proper-
ties of existing connections (interface parameters) as well as remove connec-
tions.
Connection settings assistant
The "Use connection settings assistant" function assists the user with creating
a new entry, i.e. a new connection, and with editing existing entries. The assis-
tant is always active after opening the device connections list (check mark set).
It is started whenever a new entry is to be added to the device connection list.
 Chapter 19.7.2 "Configuring the connection with the assistant", Page 241
The assistant can be deactivated by removing the check mark. If a new entry is
to be added to the device connections list then, the user must select the individ-
ual configuration steps on their own. If the device connections list is reopened,
the assistant will again be active.
 Chapter 19.7.3 "Configuring the connection without the assistant", Page 248
Establishing a connection
If the user wishes to establish a connection (or start date data transfer when
NOTE!
The USB interface is not intended for a permanent connection, since uninten-
tional removal of the USB connector cannot be prevented due to the lack of a
captive connection.