Ibml ImageTracDS 1210, Руководство по обслуживанию

Страница: 212 / 250

Maint
09-0060
9.5 Checking the pressure of the Reverse Roller
Checking the pressure of the Reverse Roller when replacing the Reverse Roller Assembly.
(1) Remove the Pick Unit assembly.
(2) Put the Thickness Gauge of 1 mm in thickness on the Reverse Cover as the Figure 1 shows.
(3) Put the Thickness Gauge of 0.5 mm in thickness on the Reverse Rollers as the Figure 1 shows.
(4) Press the Thicnes Gause of 0.5 mm in thickness in the middle between the Reverse Rollers with the Tension
Gauge.
(5) When the Thicnes Gause of 0.5 mm in thickness contacts with the Thicnes Gause of 1 mm in thickness, mearure a
value of the Tension Gauge.
(6) The measured value, the pressure of the Reverse Rollers, should be 4.3 ± 0.1 N (430 ± 10 g).
If the value is out of the range, adjust with changing the position of the Reverse Spring Support fixed with 2
washer faced head screws (305). When the the position of the Reverse Spring Support is changed by 1 mm, the
pressure of the Reverse Rollers changes by about 0.2 N (20 g).
Necessary Tolls: Phillips Screwdriver (No.2)
Thickness Gauge
Tension Gauge
Tension Gauge
Figure 1
Thickness Gauge of 1 mm in thickness
Thickness Gauge of 0.5 mm in thickness
Figure 2
washer faced head screws (305) x2
Reverse Spring Support
Strong
Weak