IBM LS42 - BladeCenter - 7902, Руководство по обслуживанию

Страница: 143 / 194

Table 4. Diagnostic error codes (continued)
v
Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v
See Chapter 3, “Parts listing, Types 7901 and 7902,” on page 19 to determine which components are customer
replaceable units (CRU) and which components are field replaceable units (FRU).
v If an action step is preceded by “(Trained service technician only),” that step must be performed only by a
trained service technician.
Message
number
Component Test State Description Action
201–826–xxx Memory Memory
Test Abort Test aborted:
Memory
controller is
disabled.
1. Turn off and restart the system.
2. Run the Setup Utility program (see
“Using the Setup Utility program” on
page 11).
3. Enable the memory controller.
4. Make sure that the system BIOS code
is at the latest level. The installed
firmware level is shown in the DSA
event log in the Firmware/VPD section
for this component. For the latest level
of firmware, go to
http://www.ibm.com/support/
docview.wss?uid=psg1 MIGR-4JTS2T
and select your system to display a
matrix of available firmware.
5. Run the test again.
6. See “Solving undetermined problems”
on page 164.
201–827–xxx Memory Memory
Test Abort Test aborted:
ECC feature is
disabled.
1. Turn off and restart the system.
2. Run the Configuration/Setup Utility
program (see “Using the Setup Utility
program” on page 11).
3. Enable ECC generation.
4. Make sure that the system BIOS code
is at the latest level. The installed
firmware level is shown in the DSA
event log in the Firmware/VPD section
for this component. For the latest level
of firmware, go to
http://www.ibm.com/support/
docview.wss?uid=psg1 MIGR-4JTS2T
and select your system to display a
matrix of available firmware.
5. Run the test again.
6. See “Solving undetermined problems”
on page 164.
Chapter 5. Diagnostics
131