IBM LS42 - BladeCenter - 7902, Руководство по обслуживанию

Страница: 60 / 194

c. Tilt the CFFh card into the card retainer brackets towards the rear of the
blade server.
d.
Press the CFFh card into the blade-expansion connector.
Removing the battery
The following illustration shows how to remove a battery from the blade server
To remove the battery, complete the following steps.
1. Read the safety information that begins on page “Safety statements” on page
viii and “Installation guidelines” on page 25
2. If the blade server is installed in a BladeCenter unit, remove it (see “Removing
the blade server from a BladeCenter unit” on page 27).
3.
Remove the blade server cover (see “Removing the blade server cover” on page
29).
4. If an MPE unit is installed, remove the MPE unit (see “Removing an expansion
unit” on page 31).
5.
Locate the battery on the system board (see “System-board connectors” on page
7).
6. Use one finger to press the top of the battery clip away from the battery. The
battery pops up when it is released.
7. Use your thumb and index finger to lift the battery from the socket.
8. Dispose of the battery as required by local ordinances or regulations.
Installing the battery
The following notes describe information that you must consider when you are
replacing the battery in the blade server:
v
You must replace the battery with a lithium battery of the same type from the
same manufacturer.
v
To order replacement batteries, call 1-800-426-7378 within the United States, and
1-800-465-7999 or 1-800-465-6666 within Canada. Outside the U.S. and Canada,
call your IBM marketing representative or authorized reseller.
v After you replace the battery, you must reconfigure the server and reset the
system date and time.
v
To avoid possible danger, read and follow the following safety statement.
Statement 2
48
BladeCenter LS22 Type 7901 and LS42 Type 7902: Problem Determination and Service Guide