IBM LS42 - BladeCenter - 7902, Руководство по обслуживанию

Страница: 71 / 194

7. Remove the heat sink.
Attention: Do not touch the thermal material on the bottom of the heat sink.
Touching the thermal material will contaminate it. If the thermal material on
the microprocessor or heat sink becomes contaminated, you must replace the
heat sink.
a. Loosen the captive screws on one side of the heat sink to break the seal
with the microprocessor.
b. Press firmly on all of the captive screws and loosen them with a
screwdriver.
c. Use your fingers to gently pull the heat sink from the processor.
Microprocessor
Microprocessor
retainer
Alignment notches
(both sides)
Locking lever
Attention: Do not use any tools or sharp objects to lift the locking lever on
the microprocessor socket. Doing so might result in permanent damage to the
system board.
8. Rotate the locking lever on the microprocessor socket from its closed and
locked position until it stops in the fully open position (approximately a 135°
angle).
9. Rotate the microprocessor retainer to the open position.
Attention:
Handle the microprocessor only by its edges. Do not touch the
contacts on the bottom of the microprocessor or in the microprocessor socket.
Touching these contacts might result in permanent damage to the system
board.
10. Use your fingers to pull the microprocessor out of the socket.
11.
If you are instructed to return the microprocessor and heat sink, follow all
packaging instructions, and use any packaging materials for shipping that are
supplied to you.
Installing a microprocessor and heat sink
The following illustration shows how to install a microprocessor and heat sink in
the blade server; the procedure for installing a microprocessor and heat sink in the
MPE unit is similar.
Chapter 4. Removing and replacing blade server components
59