IBM LS42 - BladeCenter - 7902, Руководство по обслуживанию

Страница: 169 / 194

Table 5. Additional diagnostic error codes (continued)
v
Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v
See Table 1 on page 21 to determine which components are customer replaceable units (CRU) and which
components are field replaceable units (FRU).
v If an action step is preceded by “(Trained service technician only),” that step must be performed only by a
trained service technician.
Error code Description Action
202-xxx-00n Failed system cache test.
1. (Trained service technician only) Reseat
microprocessor
n (see “Removing a microprocessor
and heat sink” on page 57 and “Installing a
microprocessor and heat sink” on page 59).
2. Replace the following components one at a time, in
the order shown, restarting the blade server each
time:
a. (Trained service technician only) Microprocessor n
(see “Removing a microprocessor and heat sink”
on page 57 and “Installing a microprocessor and
heat sink” on page 59).
b. (Trained service technician only) MPE board
assembly, if microprocessor n is on the MPE (see
“Removing an expansion unit” on page 31 and
“Installing an expansion unit” on page 32).
c.
(Trained service technician only) System board, if
microprocessor
n is on the blade server (see
“Removing the system-board assembly” on page
62 and “Installing the system-board assembly” on
page 62).
217-198-xxx Could not establish drive parameters.
1. Reseat hard disk drive x (see “Removing a SAS
drive” on page 35 and “Installing a SAS drive” on
page 36).
2. Update the BIOS code (see “Firmware updates” on
page 17).
3. Replace the following components one at a time, in
the order shown, restarting the blade server each
time:
a. Hard disk drive x (see “Removing a SAS drive”
on page 35 and “Installing a SAS drive” on page
36).
b. (Trained service technician only) System-board
assembly (see “Removing the system-board
assembly” on page 62 and “Installing the
system-board assembly” on page 62).
217-xxx-000 Failed hard disk drive test.
Note: If RAID is configured, the SAS
Attached Disk number refers to the
RAID logical drive.
1. Reseat hard disk drive 1 (see “Removing a SAS
drive” on page 35 and “Installing a SAS drive” on
page 36).
2.
Replace hard disk drive 1 (see “Removing a SAS
drive” on page 35 and “Installing a SAS drive” on
page 36).
Chapter 5. Diagnostics
157