Heraeus Kulzer Translux Power Blue, Инструкция по эксплуатации

Страница: 44 / 347

- 9 -
GB
DE
GB
FR
ES
IT
PT
NL
SE
DK
NO
FI
GR
RU
4.2.4 Acoustical signals hand piece
Function /
Error Condition
Hand piece Button operation Acoustic signal/s emitted
Indications on the hand piece
POLIMERISATION
PROGRAM: 10 seconds.
• Press the “
START / STOP
” button
briefly to start the exposure.
• 1 beep when pressing the
“ START / STOP” button.
• 1 beep at the end of exposure time.
The green LED 10 second light on.
“SOFT-START”
PROGRAM: 20 seconds.
• Press the “ START / STOP” button
for at least one second to start the
exposure.
• 1 beep when pressing the
“ START / STOP” button.
• 1 beep after 1 second for acoustic indication
of “ Soft-Start “-mode activation.
• 1 beep after 10 seconds of exposure time.
• 1 beep at the end of exposure time.
The green LED 20 second light on.
INTERRUPTION OF THE
EXPOSURE CYCLE
• The exposure cycle can be interrupted at
any time and program in use by pressing
the “ START / STOP ” button .
• 1 beep when pressing the
“ START / STOP” button.
BATTERY-LOW SIGNAL
The residual charge level
of the battery is sufficient
for a few exposure cycles.
•
2 beeps
at the end of the exposure cycle.
• Battery icon is blinking green.
Place hand piece into charger base for
charging!
SIGNAL WHEN BATTERY
EMPTY
Following exposure cycle
can’t be activated.
• 2 beeps without activation of exposure cycle.
• Battery icon is blinking green.
Place hand piece into charger base for
charging!
DEFECTIVE
BATTERY SIGNAL
Only with hand piece placed into the charging
unit.
•
1 beep
every second for a period of
30 seconds.
The battery status LED lights YELLOW.
LED Light source
defective
No acoustical signal emitted.
The green exposure cycle LED in use blinks.
OVERHEATING
CONDITION
• 3 beeps
,
and the electronics allows
termination of the exposure cycle in use.
BUILD-IN Tempera-
ture overload sensor
defective
• 4 beeps at the start of an exposure cycle.
Charging circuit of the
hand piece defective
Note:
This condition is
detected only with hand
piece placed inside the
charging unit.
Two green LED (10 s / 20 s) on the hand piece
blinking.